DO NOT CHANGE THE Z-HEIGHT. For ease of use, i suggest unchecking the “UNIFORM SCALE” and change X and Y Percentace only when editing size;

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
PLA BambuLab Matte Charcoal Transmission Distance: 0.6
PLA BambuLab Matte Ash Gray Transmission Distance: 1.5
PLA BambuLab Matte Ivory White Transmission Distance: 3.5
PLA BambuLab Matte Lilac Purple Transmission Distance: 2
This print uses 4 unique filaments

Swap Instructions:
Start with Charcoal
At layer #10 (0.88mm) swap to Ash Gray
At layer #12 (1.04mm) swap to Ivory White
At layer #20 (1.68mm) swap to Charcoal
At layer #24 (2mm) swap to Lilac Purple for the rest.