Tampa Bay Lightning LED wall sign
Copyright Claim
Tampa Bay Lightning LED wall sign
Boost
4
0
0
Print Profile(0)
Add the first print profile to earn points
Boost
4
0
0
0
3
0
Released
Description
LED and wall mount ready, Tampa Bay Lightning sign.
The backing should be printed with a 0.4mm hot end and the face should be printed with a 0.2mm hot end. Settings are preset for these different hot ends and should be ran as is. The sign is almost the entire print plate, so print plates without the factory writing are recommended. Its also recommended to not calibrate excursion as to not interfere with the print, unless you want to monitor the print and remove the calibration lines manually.
Backing is designed to be fitted with a white 5v COB LED light strip and a simple USB-c 2-pin connection. simple soldering required. 7.5ohm resistance recommended for amp reduction to COB LEDs. links below to the electronics used.
Comment & Rating (0)
All
No more
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
© 2024 MakerWorld