A lamp with the Witcher Wild Hunt logo. For printing in 3 colors, AMS recommended.

You can put any lamps or LED strip inside. Additionally, I covered the back cover with aluminum foil to obtain a reflector effect.
The rear cover is closed with 4 M3 screws (I used M3x8, but they can also be slightly longer).

Optionally, you can also use thread inserts (in project prepared hole for M3x5.7) - it's not required. If you will not use inserts you can use a little longer screws.
A cable hole is in the rear cover.

Supports and brims should be disabled.