ELEGOO Saturn 4 Tilt drain rack
Copyright Claim
ELEGOO Saturn 4 Tilt drain rack
Boost
15
36
9
Print Profile(2)
0.2mm layer, 4 walls, 25% infill
Designer
2.3 h
1 plate
compact version -1Cm
Designer
2.3 h
1 plate
Open in Bambu Studio
Boost
15
36
9
1
65
23
Released
Description
Screws: M3 self-tapping screws, length 16-30mm. *3
*！It is not recommended to use FDM PLA or SLA printing. To avoid damage to the screen due to insufficient strength.
Please be careful to choose engineering plastic printing with high layer adhesion strength.
Comment & Rating (9)
All
Will this work with the ultra?
The designer has replied
0
Reply
Yes, my machine is Ultra
0
Reply
Replying to @BilibiliIIITK
so I guess the 4 and 4 ultra have the same plates and stuff? guess I’ll make it in petg
0
Reply
Hi. Thank you for this. Do you think using an anycubic ABS or a Magforms Rigid110 engineering resin with no hollowing would have sufficient toughness to carry the plate on a Saturn 4 Ultra?
The designer has replied
0
Reply
I have never used engineering resin before~However, considering that the resin will become brittle over time, it is not recommended. Because the screen is very expensive~XD
0
Reply
But to be honest, this tilt bracket is not very meaningful because it cannot be used if the model is too long, which will cause the model to extend out of the trough.
0
Reply
Boosted
In your opinion do I need to print the short or longer one and why?
The designer has replied
0
Reply
No difference~It's just two versions modified at different times. Shorter ones are relatively better
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld