Pikachu ears for the 5 magnet NX3CREATIONSLLC Disney headband. You will need 10 6x3mm magnets and some super glue to make sure that they stay put.

I scaled the original ear model up slightly to make it easier to put in the magnets (instead of the holes being 6mm in diameter they are now approx 6.2mm). So to be safe you should also use glue for the magnets.

The ears are at a little bit of an angle so you can either wear them pointing up, to the side, or have one up and one to the side. I have the plates set up so that the bed texture will get applied to one pointing up and one to the side. You can always flip one of the ears before printing if you want the texture to match for when both ears are pointing up or to the side.

Please read before printing:

If your yellow filament is opaque (and black infill won't show through) you can use the first plate which was painted with the colour painting tool.

If your yellow filament is transparent, I've included a second plate where it was split to parts and:

• 5 layers of yellow used for top and bottom layers
• modifiers added so that before/after the yellow, black infill with 100% rectilinear is used. this way if the infill shows through it will be solid and you won't see a pattern.

If that still doesn't work you can delete the modifiers and it will print yellow all the way through, the downside is that it flushes an extra 30g of filament.

The headband in the picture was printed in PETG and you can find that model here: https://makerworld.com/en/models/207211#profileId-227331

Let me know if you have any suggestions or issues with the print. And if you print it, please post your make in the comments!