2-Level Soap Dish
Copyright Claim
2-Level Soap Dish
Boost
14
16
3
Print Profile(1)
Rotated and printed with supports for higher strength 0.2mm layer, 2 walls, 25% infill
4.1 h
1 plate
Boost
14
16
3
0
53
25
Released
Description
It can be mounted with screws by the top handle or with double-sided tape.
- Doesn't need supports if you can deal with the overhang;
- Prints well with bigger layers like 0.28 or 0.32;
- I printed in PLA;
- When mounted with screws, be cautious not to put to much stress on top or could break the top handle.
- Mounted with double-sided tape is better or with both.
Comment & Rating (3)
All
Print Profile
Rotated and printed with supports for higher strength 0.2mm layer, 2 walls, 25% infill
Good for stuff under my kitchen sink. Printed it in pink and 180x180x180mm
(Edited)
0
Reply
Print Profile
Rotated and printed with supports for higher strength 0.2mm layer, 2 walls, 25% infill
tree support instead of regular support is much easier to get rid of. but print was super smooth, thanks for sharing!
0
Reply
Print Profile
Rotated and printed with supports for higher strength 0.2mm layer, 2 walls, 25% infill
good
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld