Lamborghini 350 GT.

The first production Lamborghini that wasn't a tractor. Equipped with a V12 engine, it performed 284 PS (209 kW / 280 HP). Each car was sold at a loss during its 2 years production run, and it sold a total of 120. 

This model features 2 parts: A dedicated base and the car silhouette itself.

--------------------------------------------

CAR SILHOUETTE:

• Print it lying down on a non-textured surface (clean surface)
• Rotate it 90º on the X-axis to make the car lie down: The side that is lying down should be the one you want to see, as it will feature layer lines that are almost invisible
• Print SLOWLY and WITH A BRIM
  • Suggested brim width: 5mm
  • Suggested print speed: 30 mm/s for first layer, 50 mm/s for other layers
  • Suggested acceleration: 1500 mm2/s
  • Suggested layer height: 0.3mm for fewer layer lines when seen from the side

--------------------------------------------

CAR BASE:

• Print it standing as the file is when imported to your slicer
• Print at max. 0.2mm layer height due to overhangs
  • With 0.2mm layer height, no supports are needed!
• Print at a mediocre speed; around 100-130 mm/s with a 5000 mm2/s acceleration

--------------------------------------------

Filament: I used black PLA, which works great. My temp was set a little to ensure good flow rate, at the cost of some wisps which can be seen on my pictures too. These are easily removed. As silhouettes are black, I'll suggest you print it in black.