30 oz Tumbler Handle
Copyright Claim
30 oz Tumbler Handle
Boost
79
114
27
Print Profile(3)
Both Handles - PLA
Designer
3.4 h
2 plates
Both Handles - ASA
Designer
3.4 h
2 plates
0.2mm layer, 6 walls, 25% infill
4.4 h
2 plates
Boost
79
114
27
14
88
122
Released
Description
Add a handle to your 30 oz tumbler! It will fit most brands, but has only been tested on a Yeti.
Print Settings
No special settings are required
The following filament was used in the pictures above:
- Bambu Lab Black ASA
Comment & Rating (27)
All
Boosted
printed great. I would have scaled it down a bit.
2
Reply
Boosted
Print Profile
Both Handles - PLA
printed fine
2
Reply
Boosted
Print Profile
Both Handles - PLA
It printed great I think the next one I’ll make a little smaller for my cups I laser engrave. The handle is very comfortable and makes it easier to hold my 30oz tumblers. I wish I could figure out how to make the ring just a little smaller.
(Edited)
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
printed nice
1
Reply
Print Profile
Both Handles - PLA
2
Reply
Print Profile
Both Handles - PLA
to big for the yeti
The designer has replied
1
Reply
Just to confirm, you tried this on a 30 ounce Yeti? I have successful tested this on 3 Yetis so far, all were 30 ounce models.
0
Reply
Replying to @JamesThePrinter
I had to scale mine down 2% I have the 30 ounce and it's too big.
0
Reply
yes I have a 30ounce. I will scale it down on my next try. but love the design,
0
Reply
Print Profile
Both Handles - PLA
(Edited)
0
Reply
Boosted
my wrist is seriously loving this
0
Reply
Print Profile
Both Handles - PLA
Fit great!
0
Reply
Boosted
Print Profile
Both Handles - PLA
little big had to scale down slightly otherwise quality model
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld