MAKE SURE U USE A WHITE FILAMENT WITH A LOW 

TRANSMISSION DISTANCE!

LIKE eSUN PLA WITH A TRANSMISSION DISTANCE OF 1.6

OTHERWISE YOU PRINT WILL FAIL LIKE MY FIRST ATTEMP DID

All the designs i upload, i have to print first, and that's a lot of filament 😬 And filament isn't free..

So, if you like my work you could

buy me a coffee if you like. 😉

https://www.buymeacoffee.com/a.vdh_83

Or a donation via Paypal is also much appreciated.
https://www.paypal.com/donate/?hosted_button_id=3KZUPFUG4KLUL

Print at 100% infill with a layer height of 0.1mm with a base layer of 0.16mm

Filaments Used:
PLA BumbuLab Matte Charcoal Transmission Distance: 0
PLA BambuLab Basic Blue Transmission Distance: 4.8
PLA BambuLab Matte Dark Matte Dark Red Transmission Distance: 1.6
PLA BambuLab Basic Yellow Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 4.8
PLA eSUN White Transmission Distance: 1.6

Swap Instructions:
Start with Matte Charcoal
At layer #10 (1.06mm) swap to Blue
At layer #13 (1.36mm) swap to Matte Dark Matte Dark Red 
At layer #18 (1.86mm) swap to Yellow
At layer #21 (2.16mm) swap to Orange
At layer #22 (2.26mm) swap to White for the rest.