HueForge Fallout Helmet by Aydian

Aydian

Generative 3D Model>Hueforge & Lithophane

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.08mm layer, 3 walls, 100% infill

Designer

4.8 h

1 plate

5.0(3)

Boost

Released

Description

a new attempt of a Fallout Power amor helmet with Hueforge, I hope you like it

the settings in the file are set to Hueforge to ensure relatively good printing

Swap Instructions:

Start with Black

At layer #10 (0.88mm) swap to Gray

At layer #24 (2mm) swap to Gray

At layer #27 (2.24mm) swap to White for the rest.

Colors I used, black, white, grey

Comment & Rating (9)

@P1NFR3AK

Print Profile

0.08mm layer, 3 walls, 100% infill

I had issues with one corner not sticking to my bed and curling up but I think thats because of my 3rd party filament or humidity nothing to do with the print profile or model. Once I get the issue figured out I will definitely print more of these!

The designer has replied

@Aydian

u can use https://www.amazon.de/dp/B01HQ4KXZ4?psc=1&ref=ppx_pop_dt_b_asin_title this helps a lot

(Edited)

@P1NFR3AK

what filament are you using? the bottom right corner of mine keeps on warping up on an a1 mini

The designer has replied

@Aydian

what exactly do you mean by warping? i use Bambulab's own colors white, grey, black

@P1NFR3AK

Replying to @Aydian :

By warping I mean the bottom right corner is peeling up but none of the other corners are which makes me think its not an adhesion issue. I tried running this print at bed temp 60, 65, and 70 and none of those fixed the issue of the bottom right corner peeling up. I also applied hairspray to my bed between all prints. Going into silent mode makes the corner curl up twice as much. I believe this may have something to do with the third party filament I am using or the humidity in my print room.

@user_1786215383

You need to add the colors used and what layer to swap them

The designer has replied

@Aydian

Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Gray At layer #24 (2mm) swap to Gray At layer #27 (2.24mm) swap to White for the rest. Colors I used, black, white, grey