A mini split fender delete for your onewheel pint. This has been sliced in half to be printable on on X1C, P1P, or P1S bed sizes.

I tried to make this printable with the least amount of supports required. This is why I cut out the mud flap to be printed seperately.

It still sucks having to remove the supports, but once you do, you should be gold.

INSTRUCTIONS:

Push both fender deletes together first, then place the mud flap part under the front mini split fender part, then screw onto your board.

PRINT SETTINGS:

• SUPPORT is required. Make sure to select on build plate only for this.
• .2mm Layer Height
• 20% infill

ALTERNATE MODELS:

I've included two additional model variations:

• Mini Split Fender Only. These sit on top of your stock fender delete. You will need longer screws to mount these…3mm longer screws should work. The stock screws will not work.
• Fender Delete Only. A replacement to your stock delete incase you need one.

These alternate models require no supports when printing.

Please rate, comment and like. A boost is also greatly appreciated!