Massage tool acupressure

Massage tool acupressure

Boost
25
57
8

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
53 min
1 plate
4.6(8)

Open in Bambu Studio
Boost
25
57
8
4
73
86
Released

Description

I designed this model to participate in the mothersday contest 2024. With my idea, I wanted to emphasize that the care work mothers are providing every single day can be exhausting. So their special day should be all about them. The tool is designed for a full body massage with

acupressure technique. If you already have a mothersday gift, it can be a nice surprise for a partner as well, or you treat yourself :)

The massage tool is firm and stable if you print it with at least 15% infill (tested). The weird support is needed but satifying to peel off.

 

The design “knobble”, proves highly efficient in deep tissue massage and alleviating trigger points. Its sizable, smooth head fits snugly in the palm or between fingers. Pressure is concentrated at its rounded tip, swiftly easing discomfort. Ideal for soothing tired muscles, alleviating stiffness, and mitigating aches and pains. Particularly effective for relieving pressure at the back of the neck, offering relief from headaches.

 

When you want recreation after your workout, I also recomend treating your sore muscle with this tool.

 

For the complete wellness set, please check out my other designs.

https://makerworld.com/en/models/444987#profileId-351342

https://makerworld.com/en/models/444977#profileId-351327

 

Comment & Rating (8)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
great shape and perfect size to get deep into the muscle. rated 4 stars because the bottom has a curvature and doesn’t sit flat which makes it easier to tip while applying pressure. would recommend and I appreciate the model!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great Print!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good idea, requires support, didn't print cleanly some parts are a bit rough to the touch on 0.2, will print again with different settings and see.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
almost perfect, but since it's not even a lot of support structure is needed. I think it was a bit my fault that I haven't checked before and adjusted it.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more