My car's vent broke.

I always wanted to have a phone holder in the air vent but it was kinda impossible with these strangely shaped vents.

So I came out with this design that worked pretty well in the lats months, although it isn't the easiest to print.

The model you see is printed in BL PLA Matte, but i suggest printing it in petg.

I used ironing on the top surface because I didn't want to see the texture of the plate in this piece, but if you prefer just rotate the model.

The “VENT_sphere” is printed like this because it will be much more difficult to break; I put it in the main body without glue, but if you want to use it you can. I know I used a lot of supports but it came out to be very difficult to print with this orientation, you can use less supports if you feel to.

I used double-sided tape to keep it steady while driving, I suggest you to try mounting it without anything and use some glue if it is loose.

You can easily find my phone holder by searching the brand on amazon.

It was mandatory to me using my phone's magnet, but i bet you cant mount lots of different holders.

Let me know if you need anything!