giant gyro fidget revision. tolerance change
Copyright Claim
giant gyro fidget revision. tolerance change
Boost
71
88
15
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
16.6 h
1 plate
Boost
71
88
15
1
129
32
Released
Description
a revision of my giant gyro fidget.
modified the tolerances on the larger rings as the was potential for the outer rings to come apart.
not suitable for a1 mini. uses 90% of the larger built plate.
I would advise not to scLe down as you could affect tolerances and print may fuse together.
about 300g of filament
Comment & Rating (15)
All
has anyone actually got this thing to work?? Ive printed 3 so far. all 3 have the pegs fused together. printing the 4th now. this one will be with 100% creators settings. I'll report back tomorrow morning with results.
The designer has replied
0
Reply
Well?
0
Reply
Hmm. Interesting. I’ve personally printed 5. Can I ask what printer and are you resizing at all?
0
Reply
Replying to @Enique3d
first 3 no resize. 4th attempt was as large as i could get on my x1c. still failed.
0
Reply
Printed well, did struggle separating the rings but I got there. The stand is not deep enough to support the design well. I did enjoy the challenge overall. Thank you very kindly for the wonderful design
The designer has replied
0
Reply
Thanks for feedback. I’ve personally not had an issue with the stand apart from maybe needing some rubber feet to stop it sliding.
ill be releasing the gen 2 giant giro later today. I’ve re-build, changed a few bits. So hopefully will be better.
0
Reply
Version 2.0 now available.
0
Reply
Replying to @Enique3d
Im running it tonight I will report the follow up , thank you very kindy for your ongoing support
0
Reply
Awesome concept but it seems it has some issues. The "spinner pegs" don't seem to be deep enough as the pieces slip out easily when spinning. Also had an issue where the bottom layer stuck to the build plate. Never had this issue before, it almost seems like the bottom layer by default isn't thick enough.
The designer has replied
0
Reply
i have a refined version coming later today with better tolerances on the outer rings
1
Reply
Replying to @Enique3d
did you ever update this one?
0
Reply
has anyone built this recently with good results?
0
Reply
4 fails here over 3 days
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld