Recently bought a new phone and wanted to give this Magsafe thing a try
There are a lot of mounts that will hold a compatible charger but I just wanted to put the phone above the workstation, I already have enough cables running around.

I found this Magnetic Rings and modeled couple mounts around them:

all models can be printed in the original orientation with supports, be sure to firmly press down the model after inserting it into the pegboard holes so all the hooks can do their job properly, they're not long but they are strong.

I know it's not the best orientatrion for printing the hooks of the “lite” but, it is for the rest of model, maybe add couple perimeters and be careful when removing supports. Recommend petg for best results
No need to remove the adhesive foam to use the MagRingLite design.

Magnet ring should pressfit in the mount easily and sit flush to the surface if you remove the foam adhesive. Can use a drop of glue for a more permanent assembly, on the other side, there are four holes to help you remove the ring, poking it from the back, if needed.

MagRingPop it's for you, PopSockets lovers like me, but you don't want to remove it every time and remember where you lost it, the magnetic attraction won't be as strong as without the grip, so the phone will likely fall if you bump in it