StringTest 75 mm to 205mm by Larryjmanson

Larryjmanson

3D Printer>Test Models

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

43 min

1 plate

Open in Bambu Studio

Boost

Released

Description

This proves the X1C can create strings 74F and the filament had not been dried. The RH at the time of the test was 44% and the filament had been loaded on the machine for about a week. The filament was Elegoo Matte PLA.

The strings were created in Fusion 360 at a length greater than the rim and trimmed to the rim. The string width in fusion was .42mm and height was .15mm. I had tried a lower width but Bambu failed to produce a string when slicing. The Y axis only was expanded in the slicer by 275%. from the stl

Comment & Rating (1)

@user_1156091529

It works on X strings running on X axis also. I didn't try an XY. There are actually 2 passes on every string. The string only goes to the inner circumference of the circle and not to the exterior. i had hoped the slicer would run it to the exterior as it was modeled to give a stronger bond IMO. It is quite strong. If you squeeze the sides you can pluck it like a stringed instrument till you destroy it.

No more