IKEA Ribba Backplate / Inlay for Kinder Joy Funko
Boost
15
20
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
1 plate
Boost
15
20
5
1
16
6
Released
Description
Just a backplate / inlay for a standard 23 x 23 cm IKEA Ribba picture frame to show a collection of 12 Kinder Joy Funko Mini Characters.
Be sure to remove the purge lines on the plate before the print starts!
The Harry Potter Logo is not part of the file, you can find it here: Harry Potter Logo
Comment & Rating (5)
All
I loved that idea and made one for myself. It was hard to find the frame though cus IKEA does not sell this exact size anymore from the RIBBA model which has the depth.
The designer has replied
1
Reply
Thank you for sharing your photo. I´m glad you like it. The new deep frames ("Sannahed", as far as I know) measuring 25 x 25 cm should "theoretically" fit on the plate, but it would be very tight and I´m not sure if it would be a good print. I've seen some people print the maximum size with a special profile. Maybe I'll try it in the future and give an update ;)
(Edited)0
Reply
Thanks very much for the info. I will probably buy one and try it and will check if little rescaling will do the trick.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect, I love it.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld