Iron Maiden Revelations - Filament Painting

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Kingroon Black Transmission Distance: 0.4
PLA BambuLab Basic Blue Transmission Distance: 4
PLA EryOne PLA Magenta Transmission Distance: 2
PLA Green Transmission Distance: 4.6
PLA Kingroon Yellow Transmission Distance: 6
PLA WHITE Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #13 (1.12mm) swap to Blue
At layer #17 (1.44mm) swap to Magenta
At layer #21 (1.76mm) swap to Green
At layer #28 (2.32mm) swap to Yellow
At layer #30 (2.48mm) swap to WHITE for the rest.

How to do more than 4 colors on a single AMS?

To use more than 4 colors with a single AMS is pretty simple when it comes to HueForges.

Always start the print from either Bambu Studio or Bambu Handy App - This will allow you to map the rolls of filaments to a certain slot in the AMS:

Now map the first 4 colors (which should already be inserted in the AMS to Slots 1 - 2 - 3 - 4
Once thats done move to maping colors 5 - 6 - 7 - 8 to respectively AMS Slots 1 - 2 - 3 - 4 again!

This will allow you to Change the rolls of filament once the printer is done with that color.
For example, in the picture above once we are done with the Black color (Which is usually first) we are going to remove the black roll (you can do that while printing) with White, then once Charcoal Black is done we are going to change that to Red, Dark Gray to Yellow and we are done. ~ You can do that with as many colors as you need!

All my SINGLE AMS profiles will have a pause at the last layer of the 4th color so you can switch rolls 1,2,3 before continuing the print. This is to help you if you are not able to monitor the print and switch colors on time. (working, sleeping, giving attention to the wife)