Finger Surfboard
Copyright Claim
Finger Surfboard
Boost
21
24
14
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
22 min
1 plate
Boost
21
24
14
2
78
132
Released
Description
This is a finger-surf-board. Be prepare to ride the air in your car trips
Printed in two parts, you can glue earch other.
On top of the surface you can cuout a piece of rough paper, this will help your fingers not to slide.
In the hole you can tie any thread or fishing wire. then you tie that yo your finger so it does not fall when riding.
This works well with PLA but be carefull with the heat, it can deform if you leave it in your car.
Comment & Rating (14)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
even makes a nice bend when u peel it off!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints great and fast. used some simple nylon string to make the strap. awesome print to make a cool road trip toy!
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
The fin did not slide in place with the board, but otherwise great print quality!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
kids love it !
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
tres cool
1
Reply
Please please add this to a1 mini also :(
1
Reply
Wow!! Just printed this and it looks and feels great. Thanks for the design, much better than the rest of fingerboard designs
1
Reply
does this float?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld