Spare Tire Hold Down Clamp Bolt Holder

Copyright Claim

Spare Tire Hold Down Clamp Bolt Holder

Boost
7
4
0

Print Profile(6)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

Top - 12.9mm M8 hex head width
Top - 12.9mm M8 hex head width
Designer
49 min
1 plate

Top - 13.5mm M8 hex head width
Top - 13.5mm M8 hex head width
Designer
49 min
1 plate

Bottom- 60.1mm rim hub bore diameter
Bottom- 60.1mm rim hub bore diameter
Designer
2.3 h
1 plate

Bottom- 62.25mm rim hub bore diameter
Bottom- 62.25mm rim hub bore diameter
Designer
2.3 h
1 plate
Click to see more

Open in Bambu Studio
Boost
7
4
0
0
4
1
Released

Description

A spare tire hold down bolt holder to keep spare tires from moving around the back of the car cabin. Fits the standard M8 hex bolt. There are two pieces to print, a top and bottom part.

 

I made a variety of sizes to fit commonly found M8 bolt head widths and wheel rim hub bore diameters. If you need another size, please leave a comment. If you are unsure, the 12.9mm top and 66.25mm bottom part are good starting points.

 

The M8 hex head bolt should be greater than 35mm in length. Actual length required depends on the depth of the wheel rim and mounting screw location in the car.

 

This was made to be used with the Toyota Corolla Cross Hybrid AWD Spare Tire Upgrade kit

 

If you live in a hot climate, printing with 100% infill with PETG or PC would perform better than PLA. 

 

This model comes with no warranty and or liability. You are encouraged to bring your car to the dealer for parts and service.

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more