mother holding her sons hand heart shadow box by Liz Print Stuff

Liz Print Stuff

Art>2D Art

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.28mm layer, 2 walls, 15% infill

Designer

11.7 h

10 plates

4.6(12)

Boost

122

138

148

Released

Description

here is a shadow box with a mother holding her sons hand inside a heart. it has been updated.. Panel 3 and 8 was detached for some reason. Just added the order it should be

shadowbox

Comment & Rating (41)

@matt.ballard1

Just downloaded to try and make this for mothers day, and it looks like 3 & 8 are still separated at the top. Can you confirm these were fixed in the profile?

The designer has replied

@Liz3DPrintStuff

it was fixed

@PeterS.

Replying to @Liz3DPrintStuff :

FYI it is fixed in the stl. in the 3mf and the print profile they are still detached. :)

@charlie_whalen

turned out amazing

The designer has replied

@Liz3DPrintStuff

👍

@PinkPanther

Boosted

Printed it for my wife for mothers Day. Sie loves it!

The designer has replied

@Liz3DPrintStuff

nice

@xJEHUTYx

It’s beautiful 🥹❤️!

@user_1744458124

what kind of light did you use?? TIA.

@kumbaric

Print Profile

0.28mm layer, 2 walls, 15% infill

Beautiful! Part of a display for Mother's Day

@MatiMate

Print Profile

0.28mm layer, 2 walls, 15% infill

The designer has replied

@Liz3DPrintStuff

very nice

@charlie_whalen

Print Profile

0.28mm layer, 2 walls, 15% infill

@user_251332151

Just have a quick question, which order do the prints go in to build the shadow box? Just want to make sure I am putting them in the correct order. Thanks!

The designer has replied

@Liz3DPrintStuff

when i get home I will put the order in here yes it can be confusing

@user_251332151

Replying to @Liz3DPrintStuff :

Thank you!

@jasonxt4c

There are several issues regarding this design. There are 3 print issues in regards to disconnects. Two of them are the slides and one is the outer case itself. The designer never specified the order for which to put the slides in so it's very confusing. The outter heart ring doesn't fit correctly on the shell either. When it fits, there is a large gap on one side of the heart. It is immediately noticeable and doesn't sit well.

@dragonage24

anyone else have a good half a inch to inch between the top layer and the lid as if there should be another 2 or 3 panels