Thorn barrel redo with individual gears that spin
Remixed by
Copyright Claim
Thorn barrel redo with individual gears that spin
Remixed by
Boost
2
4
4
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
13.2 h
1 plate
Open in Bambu Studio
Boost
2
4
4
1
6
6
Released
Description
The original barrel was off center and did not spin. I cut the barrel into individual gears and centered pin to allow spinning depending on print quality. The small pin goes into center for support and strength as long as pin is printed horizontal
Comment & Rating (4)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
saw the rotating cylinder and had to get it for the thorn print out. fantastic!
The designer has replied
1
Reply
how did it work ? I hope well ?
0
Reply
Replying to @FIERCEWOLF
the spin is a little tight but honestly it's great
0
Reply
Replying to @mapplegate92
you can reprint a small gear and lower it on the build plate to reduce size and friction. also see pic one of your gears needs to be turned around
(Edited)
1
Reply
No more
© 2024 MakerWorld