28 Days Later movie poster fridge magnet
Boost
22
15
10
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
2.6 h
1 plate
Open in Bambu Studio
Boost
22
15
10
0
7
16
Released
Description
28 Days Later Cillian Murphy Danny Boyle movie poster fridge magnet.
Measuring 65mm wide by 95mm high by 5mm deep
4 colour AMS print, using black, red, white and lemon yellow.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (10)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
Looks great!
The designer has replied
1
Reply
Thanks for all the ratings and comments, I'm happy you like the designs!
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
This print came out amazing. Love the detail.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Great looking print (even though it tore my fep sheet trying to remove it from the cool plate). :)
The designer has replied
1
Reply
Thanks for the rating, sorry about the sheet though 😬
(Edited)1
Reply
Replying to @crabstiks
Have you tried printing these on the textured pei plate? I'd assume that it would not stick at some point in the print and I'd find the hothead swiping a big chunk of plastic garbage around the plate. Each of these prints on the cool plate (using Aqua Net hairspray) has been crazy to pry off (using a razorblade scraper to get under the print). But, I at least print them knowing they'll complete (unlike when I print these types of prints on the textured plate).
(Edited)0
Reply
Replying to @rggalvin
I have a dual sided smooth and textered pei plate, I've printed them on both sides with no issues, just flex the plate and they pop off. I do increase the bed temp by 5° if I have trouble with bed adhesion. Hope this helps
(Edited)1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
great hueforge-like design, unfortunately my red was too dark.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld