This luxury photo frame is not looking at all like a common 3D printed frame.
It fits standard 10 x 15 cm / 4” x 6” pictures.

You can mount on the wall or placed on the table.

• For the wall mount, there are 2 holes on the backside (landscape & portrait). In the hole is a notch to secure you frame form lifting.
• For the table stand, you just need to print the pin and the holder. It can also be mounted on both orientations.

I attached the 3mf file, so you don’t need to take care about the coloring and support.
There is a small amount of support needed (3 grams) for the photo frame itself. It can easily break away after printing. 
15% infill is enough for the frame. Only the pin I would suggest to print with more than 30% infill (already in the 3mf file set)

Printed with following Filaments:

Bambulab - Matte Latte Brown (11800)

Bambulab - Matte Charcoal (11101)

Thanks for sharing your prints with us.
Enjoy it!