I recently renewed my network setup at home with Unifi devices. That included Unifi Gateway Ultra, Switch Lite 8 POE. At first I stacked them on each other but it would have bad effect like thermal issues and also not good in terms of aesthetic and maintenance.
I spent a little time to design some panels which are parameterized and I can adjust them to any other network devices easily only by supplying width,length and depth.
I try to update this project with all small devices from Unifi to make it perfect, if there are any other devices you like just send me the depth, length and width and I make the model for you.
Updates:
I always print them on the bottom to have strength vertically, it'll be a little difficult to fit them into small printers (25x22cm bed) like Prusa MK3S+. For those printers you need to disable brim and rotate the object on the bed till it becomes green.
You can also print it face on the bed, but make sure you have really good adhesion with PETG or any other filament you use. if you have perfect layer adhesion that should be ok.
I went with Gyroid with 25% infill and it seems good for me.
I suggest do not use PLA, since it's brittle and doesn't have good thermal tolerance. I printed mine with Overture Transparent PETG because I thought it looks good and it does looks good.
Supported devices by now:
Feel free to comment and let me know if you need a panel for new device!
Network rack rails:
By your needs try to find any network rails on any seller like Amazon or others. As an example I ordered these from Amazon.nl
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.