Vinyl Record Display holder. This design uses a single screw to hold up the record holder. The screw should go into either a wall stud or a drywall plug to provide rigid and adequate support. This allows for easy levelling while providing more than enough strength to prevent the records from falling off the wall as can happen with command strip mounts.

This record holder has a relief cut in the back designed to hide the drywall plug. Relief will cover any plug with a head under 10mm and under 1mm thickness. This should be most of your standard 15lb and smaller drywall plugs. For best results use a screw inside the plug with a chamfered head so that it sits flush on your holder.

Total length is 139mm
Total height is 36.5mm
Total width is 41mm

3D PRINTING SETTINGS

Infill 20%
Wall line count 2
PLA or PLA+