This protein powder scoop precisely measures 10g of powder. Attention has been paid to good printability and handling, allowing the scoop to be printed without support material and without overhangs inside the scoop where powder could get caught. The handle and cup have been divided into two parts, which can be easily assembled.
When using the scoop, it is important to note that the 10g measurement applies to a level scoop. Additionally, if the density of your protein powder varies, the measured mass could also vary. Therefore, it is recommended to verify the mass during the first use. For corrections, the model can then be scaled (+-1g on 30g is okay ;) ).
The model was printed in PLA+, and therefore is not dishwasher safe. However, this should not be a problem since the dry powder does not require the spoon to be washed after each use. Polypropylene is unfortunately too soft for this model.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.