(Both, Metric and Freedom units, into one case).
Insert is made to fit DeWalt ToughCase+ DWAN2190. Lowes - $8.50. Tap and Die sets usually available at Home Despot.
Note, this project is just the insert, and not the case itself. The insert is 158mm x 188mm so no A-1 Version, yet.
Print looks good and fits tight in case-
So satisfying….
I added the pockets for a couple tool bits, and or the magnet thing to get the bits out easier. Also twist tie on the die handle for same.
I wanted them inset deep, so you can turn the case over and they don't spill out and mix.
Also made an indent for the reference card that I cut off the back of the packages.
Super fun little project, been wanting to do that for a while.
Thanks,
HL