Mamasaurus Light Box
Mamasaurus Light Box
Boost
65
81
4
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
3.9 h
2 plates
Boost
65
81
4
3
46
28
Released
Description
You better clean your mess up or Mamasaurus will be coming for you.
Glue stand on for best results
Back just presses in
Only logo is set up for light
The back piece in my profile just has a negative cylinder so you can adjust for whatever plug you will use
Comment & Rating (4)
All
Boosted
this is funny
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
lots of pinholes and the box itself it to small to put lights in. Too bad it’s a fun box.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
printed well. used a1 and pla
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld