I couldn’t believe this wasn’t already an available model! Here’s my version of the Tags and Crests found in Digimon Adventure, so you too can relive your dreams of being a Digidestined.

The tag is approximately 53mm tall, perfect for a necklace or keychain.

This prints as two separate pieces that can be combined after. The print profiles are set up so all the crests are on one plate and the tag is on the other.

It has quite a tight friction fit to hold the crest in place.

For best results, use a 0.2mm nozzle. It should still be possible with a 0.4mm nozzle but be aware it will lose the finer details.

Behind the model

I made this in SolidWorks with a variety of reference images, before printing on my BambuLab P1S. The tag is in eSun Silk PLA, the crests are eSun PLA+.