Rubber band plane launcher
Copyright Claim
Rubber band plane launcher
Boost
1
1
7
Print Profile(1)
0.15mm layer, 4 walls, 30% infill
Designer
1.3 h
1 plate
Boost
1
1
7
0
1
5
Released
Description
After designing my original rubber band plane, it flew far but it wasted a bit much filament. I wanted a model that was easy to print and flew super far. This design is meant to accomplish that. It is fast to print and can shoot with a rubber band slingshot extremely far. Here are some settings so your print doesn't fail.
Setting:
0.2mm layer hight
15% gyroid infill
Supports: Off
Brim: doesn't matter
Comment & Rating (7)
All
Print Profile
0.15mm layer, 4 walls, 30% infill
The print worked perfectly!
Edit: The Plane does not fly at all though :/
(Edited)
The designer has replied
0
Reply
Thank you!
0
Reply
I'm sorry to hear that. You can use hot glue or modeling clay to balance the plane to make sure it'll fly properly.
0
Reply
Nice design :) probably good to add a print profile so people can directly print it from the app.
The designer has replied
0
Reply
I am going to make profile now. The only issue is that I do not have a bambu printer but I will do my best to make the print profile good!
0
Reply
Replying to @Retrofire
I can testprint it for you and rate your profile :)
0
Reply
Replying to @user_1599109376
That would be amazing! I'm a small creator so rating my print profile would be amazing!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld