F1 Coaster Holder or Container
Copyright Claim
F1 Coaster Holder or Container
Boost
31
51
5
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
6.9 h
3 plates
0.2mm layer, 3 walls, 15% Gyroid infill - floating object fixed + supported
7.1 h
3 plates
Boost
31
51
5
0
59
51
Released
Description
The container I have designed as storage for coasters I designed
Can be used as a storage container.
the “Hub” presses into the top and secures (tight fit)
Change colours to how you wish.
Coasters https://makerworld.com/en/models/44089#profileId-45508
Comment & Rating (5)
All
Im not sure, but i think the upper part (with the rim) is missing some layers. I cant print it properly. Am i wrong? Tried to printing it with different filaments, but its always ending in Spaghetti haha.
The coasters with the Team Logos are printed all good!
1
Reply
The thin line around the wheel doesn't even exist until layer 3... So it is literally printing in the air with this profile almost half a mm up.
(Edited)0
Reply
I uploaded a profile to fix this issue today. The designer could still fix theirs but at this time it needed one to fix the floating object and also to add supports to it in the areas needed.
1
Reply
Thank you! I printed it with Supports, but it didnt Look good. So thank you for uploading the fixed Version.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld