MARIO BLOCK POST-IT 3'' HOLDER
Boost
64
112
31
Print Profile(3)
0.2mm layer, 2 walls, 10% infill
Designer
2 h
1 plate
Regular print, 0.28mm layer, 2 walls, 15% infill
1.4 h
1 plate
0.24mm layer, 2 walls, 15% infill
1.8 h
1 plate
Boost
64
112
31
2
134
117
Released
Comment & Rating (31)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
Worked without issues. Great design as well.
1
Reply
Had some issues with the center of the question marks. A little work with a razor knife got it cleaned up good enough for my desk. Fits 3X3" post it notes perfectly.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
all good but had a hard time getting the support off recommend using PLA+
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Added some supports based on reviews I read. Print turned out great and wife loves it.
Thanks.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
This printed well and looks great on my desk. I had a bit of warping and lifting at 2 corners but not enough to affect functionality.
0
Reply
Print Profile
Regular print, 0.28mm layer, 2 walls, 15% infill
The model is great but details in the description about the best method of print would have been helpful
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Cool idea, great model and very good print profile. I was a little worried about the support, but it worked very well.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld