6U Gridfinity Modular Drawer System Remixed by Isambard

Remixed by

Isambard

Tools>Organizers

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 15% infill

15.8 h

2 plates

4.5(2)

Boost

Released

Description

Here is the full set of 6U drawers. I have also included a reduced filament hex model which is the one I have personally verified. It still fits with Walter's system, its just taller!

Unfortunately I primarily use ABS so experienced extreme warping even with glue and sticking the build-plate down with Kapton tape, so I would advise against using this material. I used the original handles, scaled in XY by 120% and it seemed to be a nice press fit, however I still bungled one of them.

I will continue to iterate on this design for a while; I have a few more adaptations of the shell and drawers if anyone is interested as well.

Printing recommendations:

PLA or PETG
Back on the build-plate
0.16mm layers
15-20% cubic infill
Infill combination ON
Normal supports at 45deg

My print settings (Which I don't recommend):

eSun ABS+ White and Bambu Lab ASA Blue
0.16mm layers
20% cubic infill
Infil combination ON
Normal supports at 45deg
5mm brim; Object gap 0.1mm

Comment & Rating (3)

@hectorri

Great remix. Thanks for sharing!

@Neo3D

Print Profile

0.2mm layer, 3 walls, 15% infill

Printed well. Uses a lot of filament though, but otherwise a nice print. Suggestions: Have drawers with slightly thicker outside walls (perhaps one or two extra walls) for studier drawers. Also a version will deeper drawers, so maybe an extra Gridfinity unit, so instead of 5x3, maybe 5x4… would allow to store bigger items in the drawer. Thanks.