100mm Exhaust Adapter to fit existing holes by linton

linton

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 2 walls, 25% infill

Designer

1.9 h

1 plate

5.0(6)

Boost

Released

Description

ADD A 100MM EXHAUST PIPE

This is a bracket to attach to the back of your printer and fits to existing screw holes (see diagram image) for adding a hot swappable 100mm exhaust pipe for ventilation.

Items used:

Instructions:

Use a standard M3 thread tap to thread the three unused holes on the panel (no drilling required).

You can use about a 10mm long screw no issues. The holes on the model line up perfectly and have a small tolerance to account for material shrinkage. The second printed part you need to tape to the insulated flexible pipe as shown in the photos and there is a slot which is locks onto with a small turn and allows you to hot swap your hose with other devices.

Printed and tested on a bambulabs P1S.

Comment & Rating (7)

@traxxas

Print Profile

0.2mm layer, 2 walls, 25% infill

Nice, but it fits not very tight. It hold well together, but there is an gap the air can flow sightly through. Its a Great Model and i would reprint it, next time i would scale 1 Part a bit up. Thank you for your work.