Rose Earrings
Rose Earrings
Boost
107
185
9
In Contest
0.2mm nozzle Design ChallengePrint Profile(2)
0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill
Designer
19 min
1 plate
0.4mm Nozzle
11 min
1 plate
Boost
107
185
9
5
72
53
Released
Comment & Rating (9)
All
Boosted
Print Profile
0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill
Very Pretty!
1
Reply
Kudos, they look great with the 0.2. Printed a few sizes and colours. Supports were needed as they get a little bigger to keep them on the bed
1
Reply
Print Profile
0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill
Super cute! Had to use a lot of supports to get it to stick :D
0
Reply
Print Profile
0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill
NICE
0
Reply
Boosted
The details are incredible, a superb use of the 0.2mm nozzle !
0
Reply
These are so cute but I cannot get them to adhere to the print bed on my A1 mini. I’m using the same print parameters listed and am cleaning the bed with soap/water and ipa. Any advise?
0
Reply
Print Profile
0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill
1
Reply
Print Profile
0.4mm Nozzle
0
Reply
Print Profile
0.2mm nozzle, 0.08mm layer, 4 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld