Pokemon Umbreon Hueforge
Copyright Claim
Pokemon Umbreon Hueforge
Boost
18
25
5
Print Profile(1)
0.08mm layer, 1 walls, 100% infill
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
18
25
5
1
22
15
Released
Description
Pokemon Umbreon Hueforge!
I had a lot of fun with this one. It turned out stunning!
Dont have gold? You can always make him a ‘shiny’ variant and use a light-ish blue :)
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Gold Transmission Distance: 5
PLA BambuLab Basic White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Blue Gray
At layer #12 (1.04mm) swap to Gold
At layer #24 (2mm) swap to White for the rest.
Comment & Rating (5)
All
wish this was for the A1 mini ! 😫
The designer has replied
0
Reply
just have to resize it down to fit your bed :)
Make sure you don't change the Z height!!!!!
(Edited)0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
Boosted
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld