This is a spacer for the Tesla Model 3 phone dock.
It adds 6mm or 8mm of extra room on the phone dock and you can put the OE phone dock right on top.
The protruding nob on the top side of this spacer is not designed as good as I expect it. This is because the OE nob is spring loaded and there is only so much you can do with 3D printing.
I'm open to ideas on how to over come this.
Otherwise, all other aspects of the design is a good fit....I spend close to 10 prints to fine tune the dimensions.
Note: The side arms are design to fit a Galaxy Note 8 in landscape mode. This only fits the 8mm version.
Printer:
JGAurora A5
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
30%
Notes:
Use supports but try to space at least 1mm from walls, otherwise will be difficult to remove.