F1 RC car 1/10

14/05/2024 - V2 Update

Change material type, see on print profile for changes.

• NEW - Rear Pod, change motor mount, version V2
• NEW - Rear ride height adjusters V2, to use with new Rear POD motor mount V2
• NEW - Front, added optionals fixed caster, two solutions 6 and 9
• NEW - Front, add another support for Schumacher servo-saver, -1mm thickness
• NEW - Mid, add a new side link more stiff.
• UPDATE - Mid, center chassis, minor update (not essential)

24/04/2024 - First revision published

THIS IS A PROTOTYPE

On Truck test
 

Remember, this is an hobby for me, I'm not responsible for any damage during assembly fase.
Use your brain and have fun.

Remember, this is a 3D printed car, do not overtight screw during assembly.

This car is designed by using Fenix Racing F1Tyres
Changing tyres may be change track with car, you may use different shim to adjust front and back global with.

To finish the car you must buy different material, this is the list of most important material i use:

• Differential gear from Fenix Racing
• Composite Steering Block - Tamiya or Xray etc etc (I'm using from an OLD Tamiya only because I've have it at
  home)
• Kingpin from Schumacher Icon F1 world - U8671 ( this is important, 36mm length )
• Low pivot from Schumacher Icon F1 - U8136 ( you can use pivot from Xray F1 or roche F1)
• Servo saver from Schumacher - U4328

In my setup i use:

• ESC - Hobbywing XR10 Justock G3S
• Motor - Hobbywing XR10 Justock 21,5t
• Servo - Team Powers Digital Coreless Servo V3