Picture made in hueforge. It gives a awsome glow in the dark effect with the filament i used. You could easily replace the color with white and get a nice looking image without glow effect.
You dont need AMS to print this, but it does all the filament changes for you. This model is only 4 colors
Instructions:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm
Filaments Used:
PLA MATTE Sunlu Matte Black Transmission Distance: 5
PLA+ Sunlu Grey Transmission Distance: 2
PLA+ Sunlu Orange Transmission Distance: 5
PLA Spectrum Glow in the Dark Transmission Distance: 5
Swap Instructions:
Start with Matte Black
At layer #12 (1.12mm) swap to Grey
At layer #14 (1.28mm) swap to Orange
At layer #20 (1.76mm) swap to Glow in the Dark for the rest.