v1版本组装需要胶水，额外提供了v2版本给不想使用胶水进行组装的人

可容纳最多11个色卡Textured Color Swatch 有纹理的色卡 来自 云端的风 - MakerWorld

The v1 version requires glue for assembly, and an additional v2 version is provided for those who do not want to use glue for assembly
Can accommodate up to 11 color swatch。

注意

***柱子推荐使用花瓶模式单独打印，但您也可以使用0层顶面、0层底面、1或2层墙、0%填充的设置和其他部分一起打印***

下面是一个v1版本简单的组装指南

take care

***The column is recommended to be printed separately using the vase mode, but you can also print it with the settings of 0 layer top, 0 layer bottom, 1 or 2 layers of walls, 0% fill, and other parts together***

Here is a simple assembly guide for v1 version

1、所有需要的零件

为防止打印失败以及方便组装，建议打印时给打印版涂胶，而不是使用裙边

1. All required parts
To prevent printing failure and facilitate assembly, it is recommended to apply glue to the printed version instead of using a skirt when printing

2、组装外框和顶面

使用瞬干胶进行粘接

2. Assemble the outer frame and top surface
Use instant adhesive for bonding,

3、组装框架和柱子

定位后将柱子和单侧框架使用瞬干胶进行粘接，注意只需要将柱子粘在一侧，另一侧无需粘接

3. Assembling frames and columns

After positioning, use instant adhesive to bond the column and single-sided frame. Note that only one side of the column needs to be glued, and the other side does not need to be glued

4、将连接件从框架末端滑入

如果你的打印质量没有问题是不需要对框架末端进行额外打磨的，可以直接组合并保持一个比较紧实的手感

4. Slide the connector into the frame from the end

If your printing quality is not a problem, there is no need for additional polishing of the frame ends. You can directly combine and maintain a relatively tight feel

5、将色卡装入并将另一侧滑入连接件完成组合

色卡的模型可以在这里下载Textured Color Swatch 有纹理的色卡 来自 云端的风 - MakerWorld

您也可以自行建模，要求色卡的长宽在3*3cm以内，且中心有直径1.5cm的孔

5. Insert the color card and slide the other side into the connector to complete the assembly

The color card model can be downloaded hereTextured Color Swatch 有纹理的色卡 来自 云端的风 - MakerWorld

You can also model it yourself, requiring the length and width of the color card to be within 3 * 3cm, and a hole with a diameter of 1.5cm in the center