This is a pressure fit case for the Arduino Pro Micro USB C variant from DIYMORE, easily accessible from Amazon or Aliexpress etc.

This is my first dive into CAD software, I would appreciate constructive feedback!

Variants Offered:

• Top and Bottom with Cable Hole at Rear (5mm diameter)
• Top and Bottom without Cable Hole at Rear
• Top with Logo
• Top without Logo

At .2mm Quality and 20% infill, total print time is 50 minutes +/-, using est. 6g or 2.17m of filament.

Deburring of the mating extrudes may be helpful to allow for better fitment.

No supports necessary.

Depending of Filament choice, board LEDs will be visible through surfaces.

If not desired, place electrical tape inside of case to reduce transparency.