xtouch enclosure for Bambu Lab P1P &P1S Remixed by printingsolutions.info

Remixed by

printingsolutions.info

3D Printer>3D Printer Parts

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 4 walls, 25% infill

Designer

2.5 h

1 plate

4.9(87)

0.2mm layer, 3 walls, 10% infill

2.3 h

1 plate

4.8(12)

Boost

201

115

442

424

Released

Description

My remix xtouch enclosure for Bambu Lab P1P &P1S includes an optimized micro SD Card slot and pen holder.

A simple enclosure for the xtouch P1P/S interface by xperiments: https://github.com/xperiments-in/xtouch

This version houses the ESP32 touch screen in a way that replaces the standard printer controls, but swivels up out of the way to reveal them when needed. You get the appearance of a single touch screen, without losing access to the original control panel.

Hardware:

The required ESP32 touch screen is linked on the xtouch GitHub readme.

A USB-A to USB-B micro cable approxmately 200mm in length is ideal.

6 x M3 x 12mm countersunk bolts for attaching the rear to the front pieces.

2 x M3 x 12mm bolts for attaching the enclosure to the adaptor.

1x 2.8-inch ESP32-2432S028R board (ESP32-2432S028R or ESP32-2432S028R)

1x micro sd Card

Further informations:

https://github.com/xperiments-in/xtouch

Easy LED Riser fits for P1P and P1S and supports cable management for xtouch display and LED mounting:

https://makerworld.com/de/models/45124#profileId-46838

Comment & Rating (115)

@EdwinKort

Finally I had the right screws to mount this enclosure. The M3x12 from the local hardwarestore didn't really fit. Now I'm going to fight with the riser for the cables. And then trying to insert the plug in the internal USB connector.

(Edited)

The designer has replied

@user_2457679161

You use the wrong screws, please use m3x12 DIN 7991. 😉

(Edited)

@HorizonFly_FPV

la pièce est à l’envers.. 😌

@EdwinKort

i have those now

@nevesm

Print Profile

0.2mm layer, 4 walls, 25% infill

sehr schick und leicht zu installieren

The designer has replied

@user_2457679161

Danke fürs Feedback 😉

@djaymann2000

Print Profile

0.2mm layer, 4 walls, 25% infill

PETG

@djaymann2000

Thank you! PETG Printing the spacer to hide the cord next

@danielguddas

Print Profile

0.2mm layer, 4 walls, 25% infill

Quite a great model. Printed in PLA+.

@AyleenDayoss

Print Profile

0.2mm layer, 4 walls, 25% infill

very nice ! Didn't have counter sink screws so used the classic ones and it still fits. Had to use M3x16 for the hinge, the 12 ones didnt reach the nuts. I was a bit worried the support pressed on the pause and return buttons but it doesn't seem to matter.

(Edited)