Iphone 13 TPU case with camera protection
Remixed by
Copyright Claim
Iphone 13 TPU case with camera protection
Remixed by
Boost
13
28
11
Print Profile(1)
0.16mm layer, 3 walls, 100% infill
Designer
2.6 h
1 plate
Boost
13
28
11
0
85
67
Released
Description
This is a remix of https://www.printables.com/de/model/396766-iphone-13-case . I removed the logo and added a camera protection.
It was printed from TPU with a layer height of 0.16mm without supports.
Comment & Rating (11)
All
Print Profile
0.16mm layer, 3 walls, 100% infill
very nice!👍🏻
(Edited)
1
Reply
Print Profile
0.16mm layer, 3 walls, 100% infill
1
Reply
Print Profile
0.16mm layer, 3 walls, 100% infill
Printed in neon green TPU, a cool talking piece to show off. Thanks!
1
Reply
Print Profile
0.16mm layer, 3 walls, 100% infill
awesome file to work with it fits the phone well quality was pretty good only hiccup each print is the phone charger port to far of a distance with TPU needs support but have yet to try. printed twice coworker use the TPU me so it the decent of design thanks
1
Reply
Print Profile
0.16mm layer, 3 walls, 100% infill
Printed good, did not cover the entire phone though and the camera cover falls off easily
1
Reply
Print Profile
0.16mm layer, 3 walls, 100% infill
The print was pretty good. The lens protector could have been done a bit better (it seemed to be hard to make fit properly).
1
Reply
Print Profile
0.16mm layer, 3 walls, 100% infill
great profile
0
Reply
Print Profile
0.16mm layer, 3 walls, 100% infill
1
Reply
Print Profile
0.16mm layer, 3 walls, 100% infill
1
Reply
Print Profile
0.16mm layer, 3 walls, 100% infill
1
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld