This is a remix of https://makerworld.com/en/models/186291?from=search#profileId-205082

it's only a small remix to suit my purposes and board.

It's an alternate bottom to the case that allows the board i purchased from aliexpress to fit nicely.

The board in question: https://www.aliexpress.com/item/1005005641775572.html

• Removed corner pin holes (my board doesn't have them and would fit with them in there.
• Extended IO pin slot area to fit nicely.
• shaved down the middle section a little to allow for the original lid to fit with the board in place.

I personally used PETG with a standard 0.2mm profile for the P1S 0.4 nozzle and a Textured PEI Plate that has been rubbed with 0000 steel wool.