Pikachu Pokeball by Gumnut Forge

Gumnut Forge

Toys & Games>Characters

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.16mm layer, 3 walls, 10% infill

Designer

6.2 h

5 plates

Open in Bambu Studio

Boost

Released

Description

As part of my endeavor to make a custom Pokeball for each of the OG Pokemon here is my Pikachu Pokeball.

Please keep in mind that I have already allowed assembly tolerances to each piece but depending on your printer and settings you may have to slightly adjust this scaling.

(Ear should be fixed now)

Please consider subscribing to my young Youtube channel as that is what's allowing me to keep making these for free : )

What Pokeball do you want to see next?!?!?!

Comment & Rating (9)

@tim.bey

one ear isnt fitting

The designer has replied

@GumnutForge

That's not the ear for the other side is it? one is designed to be on a lean. worst case scenario warm the part up so its malleable and it should fit.

@tim.bey

Replying to @GumnutForge :

i also think, that is not the correct ear. but i tried both...😅 and the other one fits in the other hole correct.

@GumnutForge

Replying to @tim.bey :

hmmm.. I'll have to print it all out again and see whats going on when I have time then, thanks for bringing it to my attention mate : )

@jennifer.stynos

Where can we find the stand pictured?

The designer has replied

@GumnutForge

I'll add it to my account now mate : )

@jennifer.stynos

Replying to @GumnutForge :

thank you so much! was the issue with the ear fixed from the first comment? I hope so cause I have 4 pokeballs printing.....lol

@GumnutForge

Replying to @jennifer.stynos :

I believe so, if you have trouble with it though please let me know and I'll revise it straight away so that all you'll need to reprint is the ear..... But it should be good to go : )