An ashtray or cup/trashbin with a lid that I made for my brother's Audi A3.
When assembled it is 106.2 mm high and has the largest outside diameter of 85 mm (top).
The built-in/inlaid steel cup is optional and is not required for normal use.
I only installed it for easier cleaning and additional protection from potentially glowing ash residue.
To attach the lid to the cup, you need an M4x35 screw and an M4 nut or a 4 mm rod, which you can secure against falling out using glue.
The hole has a diameter of 4.2 mm, so it should fit snuckily in it.
Keep in mind that this print works with the basic Bambulab settings for both PLA or PETG.
If you want to use it in the car it is highly recommended to use PETG becaus of the higher temperature resistance and obvlsy ash can get hot.
The two pictures with brim on the plate are older versions, the brim isnt needed and was removed.
So in short:
This prints perfectly in PETG or PLA ( i printed both and they work without problems, no brim or support needed anywhere)
PLA print takes 2h41mins
PETG print takes 3h15 mins (around 108 g filament)
Needed other materials:
or
Optional steel cup:
Amazon → QUCUMER 6 Stück Edelstahlbecher 230ml (50 reviews 230ml)→ costs 17 Euro for 6 steelcups.
http://amoz.onl/2I4 ← shortend link if this deosnt work, search for the above mentionend keyword or i can also post the extra long link if you want it as a reply.