An employee name tag. Both the names and company name are customizable using OpenSCAD.

Note: Press “download STL” above to see all available STL/SCAD/etc files!

Magnets

Magnets: 4 pieces needed per name tag. (they are securely attaching)
Size: Cylinder 8mm diameter x 2.6mm height

Print instructions

You should do a pause print to add the magnets to the name tag at:

• 3.2mm, layer 16: put in “add pause print”

Make sure you position the magnets correctly: The two magnets in the text should point “up”, the two in the holder piece should point “down”. (Where up/down is either north or south pole, doesnt matter). Ideally follow the same polarity for all name tags.

Also for the top text, do a filament change to make them stand out, e.g. with white filament against a dark base.

Customization

You can also customize the nameplate to show your needed names and company.

Just downlod the SCAD file. Then install OpenSCAD on your own computer and follow the customizing instructions on this page.

If you could take a picture of an actual print, please publish it via the "post a make" button. - I am curious to see your uses in the wild.

If you like it, please have a look at all my customizable creations. There are configurable-text-based creations, multi-line label, gadget display stand, sweeping name plate, bunting banner, customizable text box III, pyramid text, name plate, Customizable text box with lid and round text. Have also a look at my configurable pack of dogs, rabbits, reindeers and santas. There are also useful coat hangers and finger toys.
Or just check out all my creations.

Have fun!