D10 Mario Party Dice (standard and percentile) by KNDesign

KNDesign

Toys & Games>Board Games

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

Standard and Percentile Dice

Designer

5 h

2 plates

5.0(5)

(D10 Standard) 0.2mm nozzle, 0.08mm layer, 4 walls

Designer

3.4 h

2 plates

5.0(1)

(D10 Percentile) 0.2mm nozzle, 0.08mm layer, 4 walls

Designer

3.5 h

2 plates

Open in Bambu Studio

Boost

114

Released

Description

Print Profile includes both standard D10 dice and the percentile version.

Recommend using .2mm nozzle as the text are tiny. Dice is design to be 30mm

Always wash build plate with dish soap and warm water! This allows for maximum adhesion.

Requirement:

Super Glue

Assembly Instruction: Dice Construction

General Rule: Ensure that the sum of the numbers on opposing sides equals 11 (110 for percentile).

Example:

1 + 0 (0 in D10 dice is also refer to side 10)
2 + 9
3 + 8
4 + 7
5 + 6

Assembly image:

pentagonal trapezohedron

percentile

Comment & Rating (11)

@iwannabethatguy

Print Profile

Standard and Percentile Dice

@putnamto

Boosted

how do i rate this

The designer has replied

@nguyeken

Hey Putnamto! Click on your profile on the top right and click on rating! Hope this helps. Thank you

@putnamto

Boosted

nice

@fiasco1999

Print Profile

Standard and Percentile Dice

(Edited)

The designer has replied

@nguyeken

Hey Fiasco, did you clean your build plate with dish soap and warm water and then let it sit to dry or wipe clean with a cloth? Usually a situation like occur due to a little bit of finger grease is sitting on top of the plate which prevents 100% adhesion, especially when you are working with 0.2mm nozzles.

@fiasco1999

Replying to @nguyeken :

1-9 printed out perfect except I stopped with a few layers left. I had changed to high quality .06 layer height. Will clean the build plate and attempt again at regular setting of .08 and see what happens. The .08 came out good.

(Edited)