Cat Tree Post Support (65.5mm ID)
Boost
10
12
2
Print Profile(1)
0.16mm layer, 3 walls, 20% infill
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
10
12
2
2
6
0
Released
Description
Cat tree was starting to wobble at the top as my cat got larger. I created this support so it was no longer dependent on one screw and could brace for the cat laying on the tree unevenly. Recommend printing in PETG with 3 walls. Add 4-8 countersunk screws for flush installation (holes for screws are 5mm ID)
Comment & Rating (2)
All
Boosted
This is what makes the 3d print world amazing. I have fairly new cat tree that recently broke that I just put on the side of the house with the trash. This should make it as good as new. Thanks for sharing!
(Edited)The designer has replied
2
Reply
I am hope your furry friends get many years of use out of it!
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld